Friday, November 22, 2013

Marking out the wheel stud holes

Making the wheels

 This shows the pointer used to find the center after the wheel is set to spin true on the jig, the wheel is not held down as there is no maching to be done.
 This shows the jig made from a wheel bearing held in a vice with the particle board table for the wheel to sit on.
Setting the wheel true in the jig using a stationary hammer handle note the pointer arm (blue) that holds the pointer.

 The wheel mounted on the hub.
This shows the front end and wheels attached.  The front end is ready to weld to the rest of the car. I have to make the rest first.


No comments:

Post a Comment